Everything else checks out okay so I'm figuring it must be the ignition module.Дuraspark II electronic ignition was used on to Ford V-8 passenger car and light truck engines. I checked out the ignition system and there is no spark. The car was running fine up until a couple of weeks ago and now won't start. I'm working on a Ford with a red Duraspark I ignition setup.The duraspark 2 module has a green wire that is supposed to connect to coil negative green wire. I have it running and stuff but i cannot seem to make the tachometer work. - Bullnose F, F & Larger F-Series Trucks - Duraspark 2 tach wiring - Hey guys, I have a ford maverick 5L in my rx7.

Run a positive feed wire from ignition switch, for when key is in the ON position, to the ignition module (red wire coming out of ignition module).

Using and wiring the cut wiring harness (two electrical wires) that connect to the two wires coming out of the ignition module.

This refers to the Duraspark II control module with a BLUE strain relief bushing The high voltage ignition coil, wider spaced terminals of the distributor cap, and.Sep 20, This Duraspark II Ignition Harness is designed to connect the components in Ford electronic ignition systems using the вЂњBlue Strain ReliefвЂќ ignition module. This refers to the Duraspark II control module with a BLUE strain relief bushing The high voltage ignition coil, wider spaced terminals of the distributor cap, and. II systems are the coil, module, and dist.

Converting your car to the Ford Dura Spark II ignition system is not only easy but well bad wiring in the D.S.

Floyd rose diagram